Herunterladen Inhalt Inhalt Diese Seite drucken

Installation - Bartscher 110-Serie Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für 110-Serie:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 51
l'apparecchiatura con il camino lato operatore, ma sempre accoppiato ad un altro apparecchio o al
muro.

Installation

Installation operations, gas or voltage conversions to other than the original, starting up the
installation or appliance, ventilation, letting out fumes, and maintenance must be done following the
manufacturer's instructions and observing the norms in force, by qualified personnel, in compliance
with the following provisions (GB):
ƒ Gas Safety (Installation and Use) Regulations, 1984
ƒ Health and Safety at Work Act, 1974
ƒ Codes of Practice, BS6173, 1982
ƒ The Building Regulations, 1985
ƒ The Building Standards Regulations, 1981
For others countries follow the relevant local rules for:
ƒ Gas board rules
ƒ Building regulations and local fire prevention provisions
ƒ Safety norms in force
ƒ Provisions of the Gas supplying company
ƒ The Electrical Norms in force
ƒ The Fire Brigade rules
Fume evacuation
Type "A1" gas appliances
It is not necessary to connect this type of appliance directly to an evacuation pipe for combustion
products. The products of combustion, however, must be directed into suitable hoods or similar
devices, connected to a reliably efficient chimney, otherwise directly outside. In their absence the
use of an extractor fan is permitted connected directly to the external environment with a capacity
no lower than that stated in table 1. This value must be increased with the air exchange necessary
for the well being of the operators, in accordance with the norms in force. (approximately a total of
3
35 m
/h per kW of gas output installed).
INSTALLATION
Preliminary operations
Remove the appliance from the packaging, ascertaining that it is intact and, if in doubt, do not use it
but call in professionally qualified personnel. After having verified that the appliance is in good
condition, the protective film may be removed. Carefully clean the external parts of the appliance
with warm water and detergent using a cloth to remove all remaining residues and then dry it with a
soft cloth. If there are still traces of glue residues, remove them by using a suitable solvent (e.g.
acetone): For no reason use abrasive substances. After having been put into place, the appliance
must be levelled by regulating the adjustable feet.
Pag. 40/77

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

212.930K1efe0520211.930K1gfe0520

Inhaltsverzeichnis