Control Panel - Faber Flow Isola Bedienungsanleitung

USE
Button
Function
A Turns the lighting system on and off at maximum
intensity.
Turns the lighting system on and off in Courtesy
Light mode.
B Turns the Motor off.
Press and hold for approximately 5 seconds to Lock
/ Unlock the Keyboard, for example in order to clean
the surface.
C Turns the Motor on at Speed one.
D Turns the Motor on at Speed two.
Turns the Motor on at Speed three.
E
Activates/Deactivates intensive speed from any
F
other speed, including motor off. This speed is set to
operate for 6 minutes, after which the system returns
to the speed that was set before. Suitable to deal with
maximum levels of cooking fumes. Can also be
deactivated by pressing button B.
Press and hold the button for approximately 5
seconds, with all the loads turned off (Motor and
Lights), to turn the Activated Charcoal Filter alarm
on/off.
24H function
G
Turns the motor On/Off at speed one and allows
recirculation for 10 minutes every hour. It cannot be
activated if the Intensive or Delay functions are in
use.
When the filters alarm is triggered, the alarm can be
reset by pressing and holding this button for
approximately 5 seconds.
These indications are only visible when the motor is
turned off.
Delay function
H
Activates/Deactivates automatic switch-off with a
30' delay. Suitable to complete elimination of
residual odours. Can be activated from any position.
It cannot be activated if the Intensive or 24H
functions are in use.
Press and hold the button for approximately 5
seconds, with all the loads turned off (Motor and
Lights), to turn the Remote control on/off.
R
REMOTE CONTROL RECEIVER.
EN

Control panel

Led
On/Off
On/Off
The buttons turn light up one at a time in
cycle.
On/Off
On/Off
On/Off
Flashes once a second.
Button B
(Flashes
Activated.
Button B
(Flashes
Deactivated.
On/Off
B flashes three times.
When the procedure terminates, the
indication shown previously turns off:
Button G flashes, indicating the need to
wash the metal grease filters. The alarm is
triggered after the Hood has been in
operation for 100 working hours.
Button G flashes, indicating the need to
change the activated charcoal filters, and
also to wash the metal grease filters. The
alarm is triggered after the Hood has been
in operation for 200 working hours.
On/Off
Button B (Flashes twice)-Remote control
Activated.
Button B (Flashes once)-Remote control
Deactivated.
twice)-Alarm
once)-Alarm
13
R
H
G
F
E
D
C
B
A
1