Editing Procedure; Editing The Settings; Parameter List; Global Parameters - Korg WAVEDRUM Mini Bedienungsanleitung

Editing the settings

Edit select (press for
two seconds)
The WAVEDRUM Mini lets you adjust the volume
of the pad, clip, and rhythm pattern.
For some sounds, you can change the pitch or trans-
position.
You can also change the effect type for effects 'a'
and 'b', and adjust the effect.
These types of adjustments are referred to as "edit-
ing."

Editing procedure

1. Hold down the Edit (CLIP/PAD) button for
approximately two seconds.
The two indicators below the button will blink,
and the display will indicate an edit page. If you're
editing an effect, the indicators below the FX but-
ton will also blink.
2. To select the parameter that you want to edit, use
the buttons to switch between edit pages.
For more about the edit pages and their parame-
ters, refer to "Parameter list."
For example if you want to edit the effect type for
effect 'a', choose
3. Edit the value.
Hold down the SHIFT button, and use the
buttons to change the value. The value will appear
in the display when you press the SHIFT button;
you'll see this value change when you press the
or button. If you hold down a button, the value
will change successively.
4. When you've finished editing, press the Edit
(CLIP/PAD) button to exit the edit pages.
note: The edited content is automatically saved
when you exit the edit pages.
14
Editing the settings
Edit page
select
(effect 'a': Type select).
Edit select (press for two
seconds) / Page select
Numeric input
note: You can also exit the edit pages by pressing
the , , or + button instead of the Edit (CLIP/
PAD) button.
note: If you want to edit the Transpose or Scale set-
ting, you must first select a sound where those
parameters are available, and then enter the edit
pages. Refer to "Sounds" (See page 68).
note: You can't enter the edit pages while the Rhythm
Pattern or the Looper is playing or recording.
note: You can also enter the edit pages by holding
down the FX button for two seconds or longer. Each
time you press the FX button, you'll step through
the edit pages in the order of

Parameter list

The WAVEDRUM Mini lets you edit the following
parameters.

Global parameters

Edit page no.: Parameter name [Default value]
: Transpose [0...12]
Specifies the key in semitone steps.
Transpose can be edited only for some of the
sounds. A value of 0 corresponds to C. Increasing
the value will raise the pitch in semitone steps.
However in some cases, incrementing this value
will make the pitch "wrap around" to the octave
below; for example at the value 6 (F#), the pitch
might be the F# an octave below, with subsequent
increments once again raising the pitch. This will
differ for each sound.
The right column of the table in "Sounds" (See page
68) indicates the value where the pitch of a trans-
posable sound will wrap around.
→ → .