Operating The Cooling Device Safely - Dometic MYFRIDGE MF1F Bedienungsanleitung

MF1F
• Disconnect the cooling device or switch it off when you turn off the engine. Other-
wise you may discharge the battery.
• The cooling device is not suitable for transporting caustic materials or materials con-
taining solvents.
• The insulation of the cooling device contains flammable cyclopentane and requires
special disposal procedures. Deliver the cooling device at the end of its life-cycle to
an appropriate recycling center.
2.2

Operating the cooling device safely

!
CAUTION! Failure to obey these cautions could result in minor or moderate
injury.
Electrocution hazard
• Before starting the cooling device, ensure that the power supply line and the plug are
dry.
Health hazard
• Opening the cooling devicefor long periods can cause significant increase of the
temperature in the compartments of the device.
• Clean regularly surfaces that can come in contact with food and accessible drainage
systems.
• Store raw meat and fish in suitable containers in the device, so that it is not in contact
with or drip onto other food.
• If the device is left empty for long periods:
– Switch off the device.
– Defrost the device.
– Clean and dry the device.
– Leave the door open to prevent mould developing within the device.
A
NOTICE! Damage hazard
• Do not use electrical devices inside the cooling device unless they are recommended
by the manufacturer for the purpose.
• Do not place the cooling device near naked flames or other heat sources (heaters,
direct sunlight, gas ovens etc.).
• Risk of overheating!
Ensure at all times that there is a minimum of 50 mm ventilation on all four sides of the
cooling device. Keep the ventilation area free of any objects that could restrict the air
flow to the cooling components.
Do not place the cooling device in closed compartments or areas with none or mini-
mal air flow.
• Ensure that the ventilation openings are not covered.
• Do not fill the inner container with ice or fluids.
• Never immerse the cooling device in water.
• Protect the cooling device and cables against heat and moisture.
EN
Safety instructions
7