Specifications; Important Safety Instructions - Makita AN450H Bedienungsanleitung

ENGLISH
3-1. Pneumatic oil
4-1. Adjuster
5-1. Hook
6-1. Contact element
6-2. Shingle guide
6-3. Shingle
6-4. Projection
7-1. Lever
7-2. Adjust plate
8-1. Magazine cap
8-2. Latch lever

SPECIFICATIONS

Min. hose diameter
Pneumatic tool oil
Dimensions (L X H X W)
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
Wear safety glasses.
･
Do not use on scaffoldings, ladders.
Intended use
The tool is intended for the preliminary interior work such
as fixing floor joists or common rafters and framing work
in 2 "x 4" housing.
For European countries only
Noise and Vibration
The typical A-weighted noise levels are
sound pressure level: 84 dB (A)
sound power level: 97 dB (A).
Uncertainty (K) : 1.5 m/s
Wear ear protection.
The typical weighted root mean square acceleration
2
value is 3.0 m/s .
These values have been obtained according to EN792.
EC-DECLARATION OF CONFORMITY
Model; AN450H
We declare under our sole responsibility that this
Explanation of general view
9-1. Coil support plate
9-2. Graduation
9-3. Arrow
10-1. Feed Claw
11-1. Air fitting
11-2. Air socket
12-1. Trigger
12-2. Contact element
13-1. Trigger
13-2. Workpiece
13-3. Contact element
Model
Air pressure
Nail length
Nail capacity
Net weight
2
END106-2
product is in compliance with the following standards of
standardized documents;
EN792 in accordance with Council Directives, 98/37/EC.
000230
Responsible Manufacturer:
Makita Corporation
ENE059-1
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
ENG046-2
8JD, ENGLAND
IMPORTANT SAFETY
INSTRUCTIONS
WARNING: WHEN USING THIS TOOL, BASIC
SAFETY PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED TO REDUCE THE RISK OF PERSONAL
INJURY, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS.
ENH013-7
For personal safety and proper operation and
•
maintenance of the tool, read this instruction
manual before using the tool.
4
14-1. Trigger
14-2. Change lever
15-1. Trigger
15-2. Change lever
16-1. Small rod
16-2. Ejection port
18-1. Cap
19-1. Drain cock
20-1. Air filter
21-1. Oiler
21-2. Pneumatic oil
AN450H
1.28 - 2.26 Mpa (12.8 - 22.6 bar)
19 mm - 45 mm
120 pcs.
5.0 mm
Turbine oil
287 mm X 276 mm X 117 mm
2.2 kg
CE2008
Tomoyasu Kato
Director
ENB109-2