Specifications - Makita AN960 Betriebsanleitung

ENGLISH
(Original instructions)
1 Safety glasses
2 Face shield
3 Trigger
4 Magazine
5 Side grip
6 Contact element
7 Compressor air output per
minute
8 Nailing frequency
9 Pneumatic tool oil

SPECIFICATIONS

Model
Air pressure
Fastener
Shank diameter
Head diameter
Applicable nail
Nail capacity
Dimensions (L × H × W)
Min. hose diameter
Pneumatic oil
Net weight
• Due to our continuing program of research and
development, the specifications herein are subject to
change without notice.
• Specifications may differ from country to country.
Symbols
The followings show the symbols used for the
equipment. Be sure that you understand their meaning
before use.
• Read instruction manual.
• Wear safety glasses.
• Wear ear protection.
• The tool has the capability of operating
in contact actuation mode.
• Do not use on scaffoldings, ladders.
6
Explanation of general view
10 Magazine cap
11 Latch lever
12 Door
13 Coil support plate
14 Graduation
15 Feed claw
16 Driver channel
17 Air fitting
18 Air socket
19 Hammer
Type
Length
END106-4
AN960
0.49 – 0.83 MPa (4.9 – 8.3 bar)
Wire coil nails
55 – 100 mm
Φ2.5 – 3.8
Φ6.5 – 7.5
Wire welded nails 55 mm – 100 mm
225 – 300 pcs.
338 mm × 153 mm × 418 mm
8.0 mm
ISO VG32 or equivalent
5.1 kg
Intended use
The tool is intended for the making pallets and wooden
boxes.
The tool is for high-volume professional application only.
Do not use it for any other purpose. It is not designed to
drive fasteners on a hard surface like steel and concrete.
PNEUMATIC NAILER/STAPLER SAFETY
WARNINGS
WARNING: Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in serious injury, electric shock
and/or fire.
Save all warnings and instructions for future
reference.
For personal
maintenance of the tool, read this instruction manual
before using the tool.
General safety
1. Any other use except for intended use of this
tool is forbidden. Fastener driving tools with
continual contact actuation or contact actuation
shall only be used for production applications.
2. Keep fingers away from trigger when not
operating this tool and when moving from one
operating position to another.
20 Small rod
21 Drain cock
22 Air filter
23 Oiler
24 Pneumatic oil
25 Thinner
26 Stove
27 Nail
28 Humid
29 Hot
AN961
Φ8.5
5.3 kg
safety and proper
ENB132-1
operation and