Protective Clothing; Protecting Against Rays And Burns; Prior To Commissioning; Installing The Welding Shield - Parkside PISG 120 A1 Bedienungs- Und Sicherheitshinweise

Safety instructions / Prior to commissioning / Installing the welding shield
open loop. Based on the out-
put voltage this welding equip-
ment may be used in these
conditions.
z Protective clothing
Whilst working the welder
„
must be protected against rays
and burns all over the body
with the appropriate clothing
and face protection. Remem-
ber the following steps:
Put on protective clothing
ƒ
before welding.
Put on gloves.
ƒ
Open windows or vent to
ƒ
ensure air supply.
Wear safety goggles and a
ƒ
mask.
Wear gauntlet gloves made
„
from suitable material (leather)
on both hands. These must be
in good condition.
Wear suitable aprons to pro-
„
tect the clothing from sparks
and burns. When required
based on the working method,
e.g. welding overhead, wear
a protective suit and, if neces-
sary, a head guard.
z Protecting against
rays and burns
Mark the work area with a
„
sign „Danger! Do not look into
flames!" to indicate the risk to
the eyes. If possible, shield the
work areas to protect persons
nearby. Keep unauthorised
persons away from the weld-
ing area.
Walls in the direct vicinity
„
of fixed work areas should
be neither light coloured
nor glossy. Protect windows
against rays passing through
or reflecting at a minimum to
head height, e.g. with suitable
paint.
z Prior to commissioning
Take the device and accessories out of
„
the packaging and check
for damages (e.g. transport damages).
„
Fasten the carrying strap to the device
„
(see Fig. C1 – C4).
Connect the electrode holder
„
earth terminal
4
chine.
Insert an electrode into the electrode
„
clamp device (see Fig. D).
z Installing the welding
shield
Install the handle
„
7
shield as shown in Fig. A.
Install the protective glass
„
7
welding shield
and the
5
to the welding ma-
8
on the welding
11
on the
as shown in Fig. B.
GB/CY 13