First Use; Fitting/Removing Brush Heads - Nevadent NSLP 3.7 A1 Bedienungsanleitung

First use

NOTE
Before starting to use the appliance, check that it is in fault-free condi-
tion. If not, it must not be used.
1) Insert the plug of the charger
2) Before first use, clean the new brush heads
3) Put the replacement brush heads into the replacement brush head holders
Then put the lid
4) Place the handset on the charger
base.
5) Allow the handset to charge for around 18 hours before using it for the first
time. The "Accu" LED
battery is under 50% charge capacity and green at more than 50% capacity
during the charging process. Once the charging process is complete, the
"Accu" LED
6) Use the handset repeatedly without recharging the battery until the tooth-
brush pulses three times or stops working and the "Accu" LED
red. Then, recharge the battery for 18 hours. Once the appliance is fully
charged, the "Accu" LED
7) Completely charge and discharge the toothbrush 3 times. The battery will
have then reached its full capacity.
8) You can now leave the handset in the charger
always have full power available.

Fitting/removing brush heads

■ To remove the brush head
■ When fitting the brush head
slides precisely into the socket on the brush head
Push the brush head
NSLP 3.7 A1
into a mains power socket.
on.
so that it slides onto the pin on the
on the front of the handset lights up orange when the
lights up green permanently.
lights up green permanently.
, pull it upwards and off the drive shaft
, ensure that the drive shaft
down until it completely covers the drive shaft
with fresh water.
flashes
after every use, so as to
on the handset
.
GB │ IE │ NI │ CY │
.
.
.
7■