Fitting/Removing The Protective Cap; Cordless Shaving - Silvercrest SRR 3.7 C3 Bedienungsanleitung

Fitting/removing the protective cap

♦ When you are not using the shaver, protect the shaving head by
putting on the protective cap 1 .
♦ Remove the protective cap 1 by pulling it downwards off the
cutting unit 2 .

Cordless shaving

CAUTION! MATERIAL DAMAGE!
► This appliance is not suitable for wet shaving!
This shaver can be used without the power cable . In this case, you
must charge the appliance before first use (see section "Charging
the battery") .
1) Ensure the cutting unit 2 is attached and locked in place .
2) Remove the protective cap 1 .
3) Press the On/Off switch
The blue control lamp
■ 10 │ GB │ IE │ NI
6 to switch on the appliance .
7 lights up .
SRR 3.7 C3