Removing And Cleaning The Shaving Head; Dismantling The Shaving Head - Silvercrest SBT 1.5 B1 Bedienungsanleitung

NOTE
►
►

Removing and cleaning the shaving head

To clean the shaving head
shaving head
1) Remove the protective cap
2) Turn the shaving head
marking on the housing.
3) Pull the shaving head
4) Dry off the shaving head
5) Also remove any remaining hairs using the cleaning brush
6) Replace the shaving head
ing head
on the shaving head
7) Replace the protective cap

Dismantling the shaving head

You can also dismantle the shaving head
particularly thoroughly:
■ 10
Downloaded from www.Manualslib.com
If...
– the shaving result deteriorates noticeably,
– the shave takes much longer than usual,
– there is any visible damage on the shaving head
... the shaving head
You can order replacement shaving heads
department (see section "Ordering replacement parts").
from the housing:
until the marking on the shaving head
Clean the shaving head
brush and/or rinse the shaving head
water.
in the direction of the arrow
│ GB │ IE │ NI
manuals search engine
needs to be replaced.
thoroughly, you need to remove the
(if fitted) from the housing.
in the opposite direction to the arrow
off the housing.
using the supplied cleaning
thoroughly if necessary.
on the housing and turn the shav-
points to the marking on the housing.
on the housing.
if you want to clean it
,
from our service
points to the O
under running
.
until the marking
SBT 1.5 B1