Cleaning Under Running Water; Thorough Cleaning - Silvercrest SRR 3.7 C3 Bedienungsanleitung

2) Tap the cutting unit 2 on a flat surface or blow off the hair
cuttings .
3) Use the brush e to remove any remaining hair cuttings .
4) Replace the cutting unit 2 flush on the appliance . Ensure that it
snaps into place and is seated firmly .
Long hair trimmer
■ Clean the long hair trimmer 4 after every use with the supplied
brush e .
■ Oil the long hair trimmer 4 around every 6 months with a drop
of sewing machine oil .

Cleaning under running water

1) Take hold of the cutting unit 2 with three fingers in the grip
recesses 3 and pull it off .
2) Hold the cutting unit 2 under the running water so that the water
flows through the shaving heads from the inside to the outside .
CAUTION! MATERIAL DAMAGE!
Hold only the cutting unit 2 under running water! The shaver
handset can be damaged irreparably if it is held under running
water .
3) Allow the cutting unit 2 to dry .
4) Replace the cutting unit 2 flush on the appliance . Ensure that it
snaps into place and is seated firmly .

Thorough cleaning

To clean the appliance thoroughly, disassemble the three cutting
heads:
1) Take hold of the cutting unit 2 with three fingers in the grip
recesses 3 and pull it off:
SRR 3.7 C3
GB │ IE │ NI │ 13 ■