Siemens SITRANS F-Serie Bedienungsanleitung Seite 9

Qualified personnel
This flowmeter system may only be set up and used in conjunction with this Quick Start and
the instructions on the electronic media provided. Installation, maintenance and operation
of the flowmeter system may only be performed by qualified personnel. Within the context
of this Quick Start, qualified persons are defined as persons who have the skills and
knowledge related to the construction and operation of the electrical equipment and
installations and have received safety training to recognize and avoid the potentially
explosive hazards involved.
Qualified personnel possess the following qualifications
1. Is trained and authorized to energize, de-energize, clear, ground and tag circuits and
2. Is trained in the proper care and use of protective equipment such as rubber gloves,
3. Is trained in rendering first aid
Note
This Quick Start does not purport to cover all details or variations in equipment, or to provide
for every possible contingency to be met in connection with installation, operation or
maintenance. Should further information be desired or should particular problems arise,
which are not covered sufficiently for the purchaser's purposes, the matter should be
referred to the local Siemens sales office (www.siemens.com). The contents of this Quick
Start shall not become part of or modify any prior or existing agreement, commitment or
relationship. The sales contract contains the entire obligation of Siemens. The warranty
contained in the contact between the parties is the sole warranty of Siemens. Any
statements contained herein do not create new warranties or modify the existing warranty.
Quick Start Safety Information for Hazardous Areas
Note
Ratings under this heading apply to specific model families
Check Your Model Number:
FUE1010 7ME3500, FUH1010 7ME3600 and FUS1010 7ME3530 only
FM-CSA installation
Read, understand and follow all safety instructions on the electronic media provided. This
equipment is rated for use in hazardous (classified) locations as stated below and must be
installed according to the 1010-304 installation drawing provided on the media. Failure to
install the equipment in the prescribed manner will result in unsafe operation. Follow all local
jurisdictional safety codes when operating this equipment. When properly installed the
equipment meets the following FM – CSA ratings.
FUH1010 IP65 NEMA 7 Interface Detector Quick Start
Operating Instructions, 06/2014, A5E02428148-AA
WARNING
equipment in accordance with established safety practices.
hard hat, safety glasses or face shields, flash clothing, etc., in accordance with
established safety practices.
Introduction
1.2 Safety Notes
7