Mounting The Terminal; Panel-Mount Enclosure - Mettler Toledo IND560 Installationsanleitung

IND560 Installation Manual

Mounting the Terminal

The panel-mount enclosure is designed to mount into a cutout of a flat surface
such as an instrument panel or industrial enclosure or door. The harsh enclosure
is designed to be placed on a desktop or can be mounted to a vertical surface with
the optional mounting brackets. Mount the terminal where viewing is optimal and
the terminal keypad is easily accessible. Observe location and environment
considerations as described in Chapter 1.0, Introduction.

Panel-Mount Enclosure

The panel-mount enclosure includes aluminum clamping brackets at the side of
the extrusion. Two Allen-head set screws are used to tighten the brackets against
the panel surface. The enclosure will mount and seal properly on panel
thicknesses from 16 GA to 11 GA.
Install the panel-mount enclosure by following these steps:
1. Loosen and remove the four Allen-head screws that secure the clamping
brackets to the side of the housing (see Figure 2-4). Use the 2mm Allen
wrench included with the terminal.
2. Remove the two clamping brackets from the housing.
3. Locate the front panel mounting gasket (Figure 2-5) included with the terminal
and remove the protective paper to expose the adhesive. Adhere the gasket to
the rear of the front panel of the terminal, ensuring that the gasket is flat and
spaced evenly on all sides.
2-4
Figure 2-4: Clamping Bracket
Clamping
bracket