Connection With Multi-Pole Cable And Ribbon Cable Terminal - bürkert 8691 Bedienungsanleitung

9.4.3. connection with Multi-pole cable and ribbon cable
Terminal
As an alternative to the bus connection model with 4-pole circular plug, there is the control head with multi-pole
cable (M12 circular plug) and ribbon cable terminal. The wiring diagram of the circular plug corresponds to the bus
connection of the M12 4-pole circular plug (see "Figure 24: " and "Figure 25: ") and can easily be connected to the
ribbon cable terminal (see "Figure 27: ").
Figure 26: Control head 8691 with multi-pole cable and ribbon cable terminal
handling the ribbon cable terminal
The multi-pole cable features a ribbon cable terminal - with M12 plug-in connector branch circuit - for AS interface
cable harness. The ribbon cable terminal contacts the AS interface cable harness by means of penetration tech-
nology which allows installation by "clipping in" the AS interface cable harness without cutting and without removing
insulation.
Figure 27: Ribbon cable terminal
34
Screws
M12 plug-in con-
nector branch circuit
english
Type 8691
AS Interface Installation
Work steps:
→
Open the ribbon cable terminal
(loosen screws and remove cover)
→
Insert cable harness conclusively
→
Close ribbon cable terminal again
→
Tighten screws
Slightly undo thread-forming screws
(approx. 3/4 turn to the left) and position them on the
existing tapped bore and screw in.