Inhaltsverzeichnis
Werbung
!
29
Hi / Lo Vacuum Mode Selection
ALWAYS ENSURE THAT THE FLOOR IS PRE-SWEPT
AND RELEVANT SAFETY SIGNS ARE DISPLAYED
Machine In Use
To operate, select forward or reverse, press the accelerator pedal.
Vacuum pick-up and water-flow will turn on if selected and the brush and floor
tool are in the lowered position, the machine will move forward.
The clean water is dispersed evenly via 'THRU- FEED'
scrubbing brushes.
The waste water is then retrieved by the suction floor-tool
(see Fig.29). Overlap each scrubbing path by 10cm to ensure
an even clean.
Do not operate the machine on inclines that exceed 11%.
If streaking occurs wipe floor-tool blades clean.
On heavily soiled floors use a 'double scrub' technique.
First pre-scrub the floor with the floor-tool in the raised position,
allow the chemical time to work then scrub the area a second time
with the floor-tool lowered.
Note: Care must be taken to reduce speed when
cornering or when manoeuvring around obstacles..
The TRO 650 / 200T has been fitted with a Hi - Lo function, this reduces the
noise produced by the vacuum motor.
To operate the Hi - Lo mode start the machine in the normal way.
When the machine is running normally the Hi - Lo light will be illuminated Blue
This means the Vacuum motor is running at 100%.
With the machine running press the Hi - Lo button once the Vacuum motor will
reduce its speed to 75% of capacity and the Hi - Lo light will NOT illuminate
Blue.
Machine Set-up Guide
www.numatic.co.uk
!
22
Werbung
Inhaltsverzeichnis
