Machine In Use; Maximum Speed Control - Numatic CRO 8055/100T Originalanleitung

Machine in Use

32
!
If streaking occurs wipe
floor-tool blades clean (Fig.33).
On heavily soiled floors use a 'double
scrub' technique.
First pre-scrub the floor with the floor-
tool in the raised position,
allow the chemicals time to work then
scrub the area a second time with the
floor-tool lowered (Fig.34).

Maximum Speed Control

35
Machine Operation
To operate, select forward, press the accelerator pedal.
Vacuum pick-up and water-flow will turn on if selected and the brush and floor tool are in
the lowered position, the machine will move forward.
Clean water is dispersed evenly via 'THRU- FEED' scrubbing brushes.
The waste water is then retrieved by the suction floor-tool (Fig.32).
Overlap each scrubbing path by 10cm to ensure an even clean.
After stopping the Vac motor will run for a further 10 seconds to collect any water left in the
vacuum hose.
Do not operate the machine on inclines that exceed 11%.
33
Use the maximum speed control knob and set desired traction speed as
required, depending on floor type and level of soiling (Fig.35).
Keep speed setting within the white gradient on the dial for optimum floor
cleaning.
The grey gradient on the dial is for setting the transit speed.
Once the Max speed has been set using the control knob on the control
panel, fine adjustments can be made using the variable control speed pedal
located on the right side of the footplate.
Cleaning
28
34
Transit
!