j
Turn the handwheel
external measuring jaws
sides of the object you want to measure. Please ensure that
you do not damage the object you want to measure by
subjecting it to too much pressure.
Measuring an object from the inside:
j
Place the internal measuring jaws
you want to measure.
j
Turn the handwheel
internal measuring jaws
on both its inner sides. Please ensure that you do not
damage the object you want to measure by subjecting it to
too much pressure.
Measuring the depth of an object:
j
Move the depth-measuring blade
j
Put the depth-measuring blade
the surface (e.g. inside a hole).
j
Slide the body of the calliper downward until you feel
resistance.
j
Ensure that you do not damage the depth-measuring blade
or the object you want to measure by exerting too much
6
pressure on them.
j
The LCD display
j
After carrying out the measurement, move the external
measuring jaws
again by turning the handwheel
j
Switch the LCD display
ON / OFF key
Tip: The LCD display
after approx. 5 minutes.
j
Tighten the locking screw
until you feel some resistance.
Examples of use
Q
Tip: When measuring, always proceed as described in the
chapter on using the calliper.
Comparison of plug and socket (see fig. C):
j
First measure the dimensions of the plug.
j
You may wish to make a note of the measurement.
j
Then measure the socket.
Deviation from a reference value (see fig. D):
j
Measure a reference object (in this case A).
j
Leave the measuring jaws
the key to obtain the zero setting (ZERO)
10
GB
inwards clockwise. Move the
7
together until they touch both
11
outwards anti-clockwise. Move the
7
apart until they touch the object
2
now displays the dimensions.
5
/ internal measuring jaws
11
off again by pressing the
5
.
10
automatically switches itself off
5
4
2
against the object
2
out of the calliper.
6
in position until it touches
6
inwards clockwise.
7
again by turning it clockwise
/
in this position and press
11
9
together
2
.