Emptying The Pulp Container; Cleaning And Storing - Silvercrest SFE 450 D2 Bedienungsanleitung

__CPE284970_Fruchtentsafter_B4.book Seite 11 Donnerstag, 1. Dezember 2016 8:35 20

Emptying the pulp container

• The pulp container 16 must be emptied
when it is full. Check the filling level
from time to time, e.g. when emptying
the micro-mesh strainer 4.
• To empty the pulp container 16:
- Turn the on/off switch 14 to 0.
- Pull out the mains plug 8.
- Wait until the micro-mesh strainer 4
has come to a standstill.
- Open the safety catches 15.
- Remove the lid 18.
- Tilt the pulp container 16 slightly, re-
move it and empty it.
- Reassemble the parts and proceed
with juice extraction.

8. Cleaning and storing

Clean the device before the first use
and after every subsequent use!
DANGER! Risk of electric
shock through moisture !
The motor block 7, the power cable
and the mains plug 8 must not be im-
mersed in water or any other liquids.
Disconnect the mains plug 8 from the
wall socket, ...
- before assembling or disassembling
the device and
- before you clean the device.
DANGER! Risk of injury from
cutting
The small blades 17 at the bottom of
the micro-mesh strainer 4 are sharp.
Please be very careful when handling
them. When cleaning by hand, please
use the provided cleaning brush 12.
WARNING! Risk of material dam-
age!
Please be careful not to damage the mi-
cro-mesh strainer 4. Do not apply to
much pressure to the micro-mesh strain-
er surfaces.
No part of the device may be cleaned
with boiling water.
Please clean all parts immediately after
use. In this way, you can prevent the
fruit residues from drying on the device
and causing possible blockage (e.g. of
the screen).
Do not use any astringent or abrasive
cleaning agents.
11
GB