Emptying The Pulp Container And The Filter; Dismantling The Juicer - Silvercrest SFE 450 C3 Bedienungsanleitung

NOTE
Add carrots one after the other into the feed tube 2: the top of the carrot
►
must be at the bottom and the pointed end at the top.
NOTE
To avoid fruit or vegetables becoming blocked in the feed tube 2, only
►
fill it when the appliance is switched on. If fruit or vegetable pieces get
stuck in the feed tube 2 and cannot be promptly freed with the pusher 1,
proceed as follows to avoid damage to the appliance:
3) Always switch the off appliance immediately after all of the fruit/vegetables
have been processed.
CAUTION! PROPERTY DAMAGE!
To avoid blockage of the juice outlet 6 and/or damage to the appliance,
►
clean the juice outlet 6 and the juice tank 5 regularly and after every use.
Emptying the pulp container and the filter
■ You can extract juices continuously until the container for fruit and vegetable
pulp q is completely full.
WARNING! RISK OF INJURY!
Remove the plug 8 from the power outlet when emptying the filter w.
►
This prevents unintentional starting of the appliance.
If the extracted juice suddenly starts getting thicker, or if you hear that the motor is
running more slowly, the filter w needs to be emptied. When you have removed
the fruit pulp, reassemble the appliance.

Dismantling the juicer

If you wish to dismantle the juicer, e.g. to clean it, proceed as follows:
1) Remove the mains plug 8 from the socket.
2) Open the clamps 4.
3) Remove the lid 3 with the pusher 1.
4) Lift up the juice tank 5 carefully. This disengages the filter w from the drive
shaft e. You can now remove the filter w from the juice tank 5.
GB │ MT
■ 54 │
–
Switch the off appliance immediately and pull the power plug 8
from the wall socket.
–
Undo the clamps 4 and remove the lid 3.
–
Remove the fruit or vegetable pieces causing the blockage.
–
Reassemble the appliance and continue with juice extraction.
SFE 450 C3