Synchronising Transmitter / Receiver - Silvercrest HG00783A Montage-, Bedienungs- Und Sicherheitshinweise

Transmitter:
Remove the holder
the transmitter and remove the rubber cover
Remove the used batteries, if present (see fig. C2).
Insert a battery (3 V
marked "+" must face upwards.
Install the rubber cover
back on to the back of the product.

Synchronising transmitter / receiver

The product works on 434 MHz which is a quite common frequency.
To ensure that the function gets no influenced be doorbells in the
neighborhood, the transmitter and the receiver hence have to be syn-
chronized in regard of the encryption. Every transmitter is working
with a different encryption of the signal.
Synchronise the transmitter and receiver as follows:
As soon as the batteries are installed, the receiver enters synchro-
nizing mode for approx. 2 minutes. During the synchronizing
mode, the signal indicator
You can also manually enter synchronising mode by holding the
synchronising button
The signal indicator
approx. 1 minute, to indicate that the receiver is in synchronizing
mode.
12 GB
by pressing the lock
12
(direct current), type CR 2032). The side
, close the holder
15
steadily lights up in blue color.
1
for approx. 3 seconds.
5
on the receiver will steadily light up for
1
from the back of
11
(see fig. C1).
15
of the transmitter
12