Sequential Washing - Faema Emblema Gebrauch Und Installation

SEQUENTIAL WASHING

1
Remove the filter holder
from the coffee group.
4
Use the "+" (30) and "-" (31) keys to pass to the Sequential
Washin cycle. The scrolling icons of the machine groups
will appear on the display.
to change sel.
to con rm
7
Pour in a packet or dosing
cupful of detergent powder.
11
At the end of the group 1
wash cycle, the message
"REMOVE FILTER HOLDER
GROUP " will appear.
R E M O V E F I L T E R
H O L D E R
G R O U P 1
p u s h
t o c o n f i r m
15
At the end of the group 1
rinse cycle, the message
"EXECUTE GROUP
WASH" will appear.
G R O U P 2 W A S H
p u s h
t o c o n f i r m
2
Using a brush, clean the
cover gasket.
8
Hook the filter holder to
Group 1.
12
Remove the lter holder.
16
Repeat the operations
described above for all
machine groups.
3
to change sel.
to con rm
5
Con rm the washing mode
using the key ; the screen
will display:
I N S E R T . F I L T E R
H O L D E R
G R O U P 1
p u s h
t o c o n f i r m
9
Press the coffee circuit wash
key (26).
13
Press the coffee circuit wash
key (26).
Do not remove the lter holder
during coffee dispensing.
24 EN
Hold down the coffee circuit
washing key (26) for a few
seconds.
The simultaneous washing
screen (preset mode) will
appear on the display.
6
Insert the rubber disk into
the lter-holder with its lter.
10
The Group 1 wash cycle will
start and the "GR WASH"
message will appear on the
display.
G R 1 W A S H
14
The message "GR RINSE"
will appear.
G R 1 R I N S E