Cleaning And Maintenance - Faema Emblema Gebrauch Und Installation

24. Cleaning and maintenance

For correct application of the food safety system (HACCP), please follow the instructions in this
Washing must be carried out using original "Service Line" products, see details on the last page. Any
other product could make the materials in contact with food unsuitable.
Procedure to effect at the end of the work day on all groups or when signaled by the machine.
COFFEE CIRCUIT CLEANING CYCLES
The purpose of the ushing cycle is to remove all traces of
grease and scaling deposited when the coffee is dispensed.
Failure to ush out the circuit will allow these deposits to
solidify. This will impair the qualitative performance of the
coffee circuit.
NOTE: the following operations must be carried out
when the machine is on and pressurized.
ATTENTION, RISK OF SCALDING: During the wash
cycles, hot water and steam will exit from the groups.
Keep the hands and all other parts of the body well
away until the cleaning cycle has terminated.
I the machine sends the
COFFEE WASHING" will appear on the display.
This message will continue to appear until the wash cycle
is performed.
The coffee circuit can be washed in different ways:
simultaneous: all groups are washed at the same time;
-
sequential: each group is washed separately and in
-
sequence. It is therefore possible to continue using the
groups not involved in the washing process.
A third type of washing cycle can also be effected:
- single: The washing cycle can be made on a speci c
group without having to wash the remaining ones.
Groups not involved in the washing cycle can still be
used during that time.
arnin messa e "EXECUTE
Note: The single washing cycle cannot be carried out
if the machine launches a warning message.
Note: If no wash cycle messages appear and the
machine is used frequently, a wash cycle can
be performed at any time.
Note. Once the wash cycle is underway, it CANNOT be
stopped, even if the machine is switched off.
If there is a power failure, when power is returned
the message "EXECUTE
displayed. Complete the cleaning operations as
described previously.
The wash cycles performed without request by the
machine can be interrupted by switching off and
switching back on the machine.
The simultaneous washing mode lasts 7 minutes. The single
washing mode lasts 7 minutes for each dispensing group.
Programmed wash cycles that are not effected will be
memorized by the machine.
To perform the washing cycles, follow the steps on the
next pages.
22 EN
paragraph.
WASHING" will be