Measurements; Set Up - voestalpine Böhler Welding URANOS 2000 SMC Betriebsanweisung

2d
VRD Voltage Reduction Device
Shows that the no-load voltage of the equip-
ment is controlled.
2e
Allows the selection of the welding method
2 Step
4 Step
Bilevel
2f
Current pulsation
CONSTANT current
PULSED current
Fast Pulse
2g
Allows the selection of the welding method
2 Step
4 Step
Crater filler
2h
Arc length
Allows regulation of the arc length during welding.
High voltage = long arc
Low voltage = short arc
Minimum -5.0, Maximum +5.0, Default syn
2i
Inductance
Allows electronic regulation of the series inductance of
the welding circuit.
Makes it possible to obtain a quicker or slower arc to
compensate for the welder's movements and for the
natural welding instability.
Low inductance = reactive arc (more spatter).
High inductance = less reactive arc (less spatter).
Minimum -30, Maximum +30, Default syn

3.5 Measurements

During the welding operation, the real current and voltage
measurements are shown on the LCD display.
3a Welding current
3b Welding voltage

3.6 Set up

Permits set up and adjustment of a series of additional param-
eters for improved and more accurate control of the welding
system.
The parameters present at set up are organised in relation to the
welding process selected and have a numerical code.
Entry to set up: by pressing the encoder key for 5 sec. (the
central zero on the 7-segment display confirms entry).
Selection and adjustment of the required parameter: by
turning the encoder until displaying the numerical code relating
to that parameter. If the encoder key is pressed at this point,
the value set for the parameter selected can be displayed and
adjusted.
Exit from set up: to quit the "adjustment" section, press the
encoder again.
To exit the set up, go to parameter "O" (save and quit) and press
the encoder.
41