Trouble Shooting; Warranty - HANSGROHE PuraVida 15775 series Gebrauchsanleitung, Montageanleitung

Trouble Shooting

Fault
Insuffient water flow
,Crossflow', hot water is forced
into cold water pipe, or vice
versa
Spout temperature does not corre-
spond wlth the temperature set
No temperature control
Shower or spout dripping

Warranty

You have purchased a quality product from Hansgrohe. All parts which show any kind of fault as far as
construction, material or assembly are concerned within the first 24 months after installation, we will repair
or exchange the part in question free of charge. Faulty items become our property.
We do not grant warranty for faults caused by:
unsuitable or improper use; incorrect assembly; installation started and/or completed by a non-qualified
plumber, natural wear out, improper or careless treatment, lack of maintenance; unsuitable usage;
chemical, electro-chemical or electrical influences.
Technical Hotline
0 870 7701975
16
Hansgrohe · Postfach 1145 · D-77761 Schiltach · Telefon +49 (0) 78 36/51-1282 · Telefax +49 (0) 7836/511440
Cause
- Supply pressure inadequate
- Shower filter seal dirty
- Thermostat cartridge filters dirty
- check valves dirty or leaking
- Thermostat has not been
adjusted
- Hot water temperature too low
- Thermostat cartridge failure or
blocked filters
- Dirt in the flow valve or ‚shut
off' unit damaged
E-mail
Technical@hansgrohe.co.uk
E-Mail: info@hansgrohe.com · Internet: www.hansgrohe.com
Remedy
- Check mains pressure
- Clean filter seal between
shower and hose
- Remove cartridge & clean the
filters on the barrel
- Clean check valves -
replace if necessary
- Calibrate thermostat
- Increase hot water temperature
- Check/clean filters
- Replace cartridge
- Clean or replace shut-off unit