Before Commissioning; Safety; Mains Connection - Würth ACCTIVA EXPERT 12/24V - 35A Handbuch

Before commissioning

Safety

Utilisation in The charger is only for charging batteries as detailed in the accompanying characteristic
accordance with data sheet. Any other form of usage is deemed „not in accordance with the intended
„intended purpo- purpose". The manufacturer shall not be liable for any damage resulting from such
se" improper use. Utilisation in accordance with the „intended purpose" also comprises
-
-

Mains connection

The rating plate, which is located on the housing, contains information about the permit-
ted mains voltage. The charger is designed for this mains voltage only. The required fuse
protection for the supply can be found in the accompanying characteristic data sheet. If
there is no network cable or mains plug on your charger, fit a network cable or plug
according to the national standards.
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. You should not use the functions described until you have thoroughly
read and understood the following documents:
- Operating instructions
- All the operating instructions for the system components, especially the
safety regulations
- Battery and vehicle manufacturers' operating and safety instructions
Following all the instructions in this manual
Regular checking of mains and charger cables
WARNING! Charging dry batteries (primary cells) and non-rechargeable
batteries can cause serious injury or damage, and is therefore prohibited.
NOTE! Inadequately dimensioned electrical installations can lead to serious
damage. The mains lead, and its fuse protection, must be dimensioned in
accordance with the local power supply. The technical data shown on the rating
plate shall apply.
3