Troubleshooting - Gastroback 42636 Bedienungsanleitung

TROUBLESHOOTING

Problem
The Hot Water LED flashes when the
machine is turned On.
The Steam LED flashes when the
machine is turned On.
Water does not flow from
the group head.
FILL TANK On in LCD display, but
water tank is full.
No Steam or Hot Water.
No Hot Water.
No Steam.
The machine is 'On' but ceases to
operate.
Steam pouring out of group head.
Espresso only drips from the portafil-
ter spouts, restricted flow.
86
POSSIBLE CAUSES
Hot Water dial is Open.
Steam Lever is Open.
Machine has not reached opera-
ting temperature.
Water tank is empty.
Water tank not fully inserted &
locked.
Water tank is not fully inserted
and locked into position.
Machine is not turned on.
Water tank is empty.
Steam Wand is blocked.
Coffee is ground too finely.
Too much coffee in the filter
basket.
Coffee tamped too firmly.
The Dual Wall filter basket may
be blocked.
WHAT TO DO
Turn the Hot Water dial to the CLO-
SED position.
Move the Steam Lever to the CLO-
SED position.
Allow time for the machine to reach
operating temperature. The POWER
light will stop flashing when machine
is ready.
Fill Tank.
Push water tank in fully and lock
latch closed.
Push water tank in fully and lock
latch closed.
Ensure the machine is plugged in,
switched On at the power outlet and
the POWER button is On.
Fill water tank.
Use the pin on the cleaning tool
to clear the opening. If the steam
wand continues to be blocked remo-
ve the tip of the steam wand using
the spanner in the cleaning tool and
soak in hot water.
Turn machine Off. Wait for 60
minutes and turn machine back On.
Turn machine Off. Wait for 60
minutes and turn machine back On.
Use slightly coarser grind.
Lower dose of coffee.
Tamp between 15-20kgs of pres-
sure.
Use the fine pin on the cleaning tool
to clear the outlet hole on the under
side of the filter basket.