Hot Water - Krups EA84 SERIES Bedienungsanleitung

AUTO CAPPUCCINO (available depending on the model)
The auto-cappuccino accessory helps the preparation of a cappuccino or latte.
Important: we recommend that you use pasteurised or UHT milk, recently opened.
!
Unpasteurised milk does not produce the best results.
Preparing the appliance:
Connect the milk suction pipe to the auto-cappuccino accessory, on the unbevelled side.
Fit the accessory on the steam outlet.
Enter the bevelled end of the suction pipe into a container filled with milk. Fig. 17.
Place a cup under the auto-cappuccino accessory.
Important: The inlet must not be twisted.
!
Recipe stage 1:
Select the cappuccino (
spout.
Press "steam" to launch the pre-heating.
Possible settings
You can change the steam time using the – and + buttons located to the
left and right of the symbols.
Press the "OK" button on the touch screen to launch the preparation.
Important: press any button to stop the steam function. The maximum duration for steam
!
production per cycle is limited to 2 minutes. Caution, the cycle does not stop
immediately.
Recipe stage 2:
Place a cup under the coffee outlet and start a coffee/espresso cycle. Fig. 18. (See chapter:
Preparing drinks using coffee beans).
Rinsing the accessory:
To ensure that the accessory functions correctly, rinse with water after each use. Your appliance
will not ask you to do this. Perform a steam cycle with a container filled with water to clean inside
the spout. Fig. 19.
To do this, you can also use the KRUPS XS4000 liquid cleaner which is available as an accessory.
Maintenance and cleaning:
Disassemble the accessory and clean the parts using a small brush and, if necessary, a little
washing up liquid. Fig. 20.
If necessary, unblock the small opening (highlighted in the illustration) using the cleaning pin
(supplied with your machine).

Hot water

Check that the steam spout is securely locked on its support.
When the screen displays the drink selection menu, press "HOT WATER". A message invites
you to place a container under the steam spout and choose the volume.
You can start producing hot water by pressing "OK".
42
) or latte ( ) setting on the auto-cappuccino