Inhaltsverzeichnis
Werbung
1
Fig. 9
Take care for the fuel and the oil not to soak in the soil.
Safety Instructions for First Putting in Operation
Before putting the engine pole pruner in operation, check whether it is in safe serviceable condition. Never start the unit if in doubt.
Observe the following steps in particular:
•
Correct installation of separate parts
•
Ease of all the switches run.
•
Safe positioning of the spark plug socket. If the socket is slack, the spark may put the fuel-air mixture on fire. .
•
Never use the pruner if the saw or handle are damaged, poorly adjusted or not safely assembled, when the starter is not working.
The chain should stop if the starter is on. Defective starters should be replaced at one only authorised servicing centre.
•
Do not use the pruner in a windy or stormy weather.
•
Beware of falling branches. Inspect the tree before pruning. Make space for falling branches and watch out for the direction of
fall.
•
Do not use the pruner for cutting sprouts or shrubs.
•
Do not work in the vicinity of flammable liquids or gases.
•
Defective chain should be replaced immediately.
•
Keep your tools clean and sharp, your work will be better and safer.
People around should be kept at a safe distance.
Operation
•
Remove oil tank cover (1).
•
Pour biologically degradable chain oil in the oil tank (2).
Application of naturally degradable grain grease of rape of
sunflower oil on guide rail and chain is recommended.
•
Replace the oil tank cover (1) and tighten it well. That will
prevent oil leakage from the tank.
•
Wipe any excess oil off. Empty the oil tank after every use (2) for
2
the oil not to pour off.
•
Shift the switch (1) towards the handle. At cold start, the choke
switch (5) has to be pushed upwards.
•
Press the fuel pump (4) ca 8-10 times to fill the fuel system. (2-3
times at a normal operation).
•
Put your hand on the handle and release the cut-out. Push the
start button in and press the lock button (2). Keepit pressed and
let the engine button go. The set-up is not ready (2).
•
Hold the saw with one hand on the clasp (4). Pull the launching
cable (6), until the engine runs. CAUTION! Do not pull the
cable too far! Watch out the running chain.
•
When the engine is running, shift the choke switch downwards
again (5). Give full throttle 2-3 times and start working.
•
After switching the machine off put the switch to (1) „STOP" (in
the direction of edge)
Werbung
Inhaltsverzeichnis
