Adjusting The Chain Lubrication - Makita DCS 9000 Wichtige Änderungen Zur Betriebsanweisung

AVOID SKIN AND EYE CONTACT
Refuelling
FOLLOW
THE
SAFETY
PRECAUTIONS
Be careful and cautious when handling fuels.
The engine must be switched off.
-
Thoroughly clean the tanks around the screw plugs to
prevent
did
from entering the fuel or oil tank.
Unscrew
t h e
plug and fill in fuel or chain oil until it reaches the
bottom edge of the filler socket. Be careful when refilling.
Do
not spill fuel or oil.
Tightly screw on the plug.
-
-
Clean screw plug and tank after refuelling.
Mineraloilproductsaswellasoilsdegrease yourskin.
If
yourskin
comes in contact
with
these substances repeatedly and for a
longer period o f time, it will desiccate. Various skin deseases
may result. In addition, allergic reactions are known.
Eyes can be irritated
by
contact with oil.
If
oil comes into your
eyes, immediately wash them with clear water.
If
your eyes are still irritated, go to
see a doctor.
Lubricating the chain
In order to ensure sufficient lubrication o f the chain there must
always be enough oil in the tank.
Its contents is sufficient for
approx.
1/2
hour o f continuous operation.
Adjusting the chain lubrication
@
The motor must be switched off.
The oil pump can be regulated with the adjusting screw
(F/l).
The
adjusting screw i s mounted on the bottom side o f the casing.
The oil pump has been adjusted to a medium feed quantity
by
MAKITA.
For changing the feed quantity use the universal wrench and
adjust the adjusting screw
(F/1)
in the following way:
-
-
turn to the right to reduce the quantity
turn to the left to increase the quantity.
To guarantee a troublefree operation o f the oil pump the oil guide
groove at the crank case
(G/2)
and
the
oil inlet bore in the guide
bar
(G/3)
must be cleaned regularly.
13