Operation; Mode Of Operation; Maintenance And Environmental Protection - Meister WS750-125M Originalbetriebsanleitung

5405130-Winkelschl_man 08.09.17 12:25 Seite 62
Additional grip
The additional handle (6) can, depending
on the way in which you are working, be
mounted to two different positions on the
sanding head (fig. 4).
8 – Operation
Switching on (fig. 7)
Push the sliding switch in the direction
of the arrow to I (On). Allow to lock into
place for two-handed operations.
Switching off (fig. 7)
Release the sliding switch, if locked,
gently press the rear section of the
sliding switch. The switch will jump to 0
(Off). Only put the machine down after it
has come to a complete standstill.
Restart protection/power failure
protection
In the event of a power failure, a
undervoltage relay is triggered. This
prevents the device being switched
back on automatically as soon as the
power supply is restored. In order to
switch the device back on when the
power supply is restored, it must be
switched off and then back on at the
On/Off switch.
Test run
CAUTION! Always carry out a test
run before starting work and after
every tool change!
Always ensure that the tools are in good
condition, correctly mounted and able to
turn freely. The trial run should last
approx. 30 sec.
62
9 – Mode of operation
• Always place the workpiece on a firm
surface before starting.
• Observe rotation direction and
function
• The distance between the user and
the machine should be as great as
possible.
• Avoid jolting the workpiece.
CAUTION! Never machine
material containing asbestos.
Cutting
Apply slight pressure to the cutting disk
from above, but NOT from the side.
Adjust forward pressure to material and
rotation speed. The machine must work
in reverse rotation (fig. 9).
CAUTION! Do not cut wet
material.
Roughing
Hold the machine at an angle of 30° to
40° to the workpiece. Move the machine
back and forward with moderate
pressure.
10 – Maintenance and
environmental
protection
CAUTION! Before any
maintenance working on the
appliance, unplug it from the mains.
Remove dust regularly from machine and
ventilation slits. Clean the case only with
a damp cloth – Do not use solvents. Then
dry well.