Klarstein Cleanhero 10009785 Bedienungsanleitung Seite 19

B. Press the button on the dust box, the fan assembly will automatically pop up (Refer to Figure 2);
Tip: water is not allowed to directly clean the fan assembly.
C. Pop up the blower, take out the filter, and then clean the dust box. (Refer to Figure 3)
D. Clean the filter by hair dryer with cold wind or using brush cleaner. (Refer to Figure 4 and Figure 5)
E. Reinstall the filter in the original position.
Tip: The rubber cleaning head sometimes might be dropped off when you clean the dustbin, please
follow the below instruction to reinstall it..
1. Position the dustbin and rubber cleaning head as picture 1.
2. Place one end of the cleaning head into the dustbin, make sure the cleaning head is upward and
connect well with the dustbin. (Refer to picture 2).
3. Make the cleaning head completely connect with dustbin by pressing with your hand.
Assembly & Disassembly of Main Brush and Floor Brush:
1. Force the locking bar forward and raise the cover by your
right thumb, then raise rod of the main brush by your left
hand. (Refer to Figure 1 and Figure 2)
2. Take out the main brush and floor brush.(Refer to Figure 3)
3. Insert the main brush and floor brush into the holes before
closing the cover in assembly.
Assembly & Disassembly of Side Brush:
1. Release the screw in the main shaft of the side brush before
you change a new one.
2. Press the side brush against the main shaft and then fasten
the screw. (Refer to the figure)
19