Adjusting Direction Of Approach - SICK T4000 Bedienungsanleitung

4
Chapter
Fig. 1: Minimum
distance
Fig. 2: Change in
the switching
distance with
flush installation
150
© SICK AG • Industrial Safety Systems • Germany • Subject to change without notice • 8012206/UC32/2010-11-15
Installation
 When installing the actuator flush, note that the
switching distance will change as a function of the
installation depth and the material from which the
guard is made.
Flush installation
4.2

Adjusting direction of approach

Depending on the mounting position of the actuator and
read head, it may be necessary to change the direction of
approach.
The sensing face of the read head is marked by the yellow
area. It can be changed in five directions. The centre of the
sensing face is also the centre of the read head.
min. 80 mm
Surface installation
Actuator
Response range
Operating Instructions
T4000 Direct Unicode