Mounitng Roof, Installation Unit And Columns - HANSGROHE PHARO Duschtempel 100 Montageanleitung

M o u n t i n g r o o f , i n s t a l l a t i o n u n i t a n d c o l u m n s
4
5
40
1
2
3
Mounting holders of the installation unit
Measurements are in relation to between the shower tray edge
and drill centres. Seal holes with silicon, free from acetic acid.
Mark left and right fixing point of the holding angle (3), punch
and drill holes Ø6.
Secure holding angle with Phillips screw 5x35.
Mark left and right fixing point of the wall holder (1), punch
and drill holes Ø8.
Secure wall holder with hexagonal wood screws 6x50 and
washer 6,4x10,6.
Mounting clamping ledge
Separate clamping profile (5) from clamping ledge (4).
Mark left and right on the wall the fixing points of clamping
ledge (2, punch and drill.
Use acetic acid free silicon on the clamping ledge.
Align the clamping ledge vertically. Secure clamping ledge
with Phillips screws 4x45.