Loading The Batteries; Error Warning; Auto Power Off - Sigma EF-630 Gebrauchsanleitung

LOADING THE BATTERIES

1. Turn the power switch to [OFF] and open the battery compartment
by sliding the cover. P.3-(1)
2. Follow the indication in the battery compartment and insert the
batteries with the "+" and "-" electrodes in the correct direction.
P.3-(2)
3. Close the battery compartment cover. P.3-(3)
4. Turn the power switch to [ON]. When the flashgun is charged to
the level that flash firing is possible, the Ready light starts blinking
in green. When the flashgun is fully charged, the light lights up in
red.
Caution!!
When the battery capacity gets low, the
mark is indicated on the LCD panel. When the
battery capacity decreases to zero, the display
indicates the mark on the right, and the flash will
no longer function. Please replace the batteries.

ERROR WARNING

When the mark is indicated on the LCD panel, the flash may
have failures. Reset the power switch or check the battery. If the
indication remains, contact our sales office.

AUTO POWER OFF

To conserve battery power, the flash unit automatically turns itself off
when the flash has not been used for approximately 1.5 minutes. To
turn the flash on again, depress the TEST button or the camera
shutter button halfway. However, the auto power off does not work in
[WL ] mode, [S-FL NORMAL] mode and [S-FL
SLAVE
22
ATTACHMENT TO THE CAMERA
1. Turn the power switch to [OFF].
2. Confirm that the shoe lock lever is in the [UNLOCK ►] position.
P.3-(4)
3. Insert the flash on to the hot shoe of the camera until it stops.
Slide the shoe lock lever to the [◄LOCK] direction until the lever
is locked with a clicking sound. P.3-(5)
When removing the flash, slide the shoe lock lever to the [UN
LOCK►] direction until it stops while continuing to press the shoe
lock lever button. Then pull out the flash.
Caution!!
If the flash is pulled out while the shoe lock lever is not in the
[UNLOCK►] position, the hot shoe of the camera and the
attachment shoe of the flash could be damaged.
ADJUSTING THE FLASH HEAD
In regular shooting, set the flash head to face forwards. P.3-(6)
Caution!!
After the power switch is turned to ON, if the
indicated in the Status area, or if the distance indication in the Status
area is blinking, the flash head is not correctly set to the front
direction.
] mode.
SLAVE
mark is