Residual Risks; Assembling Instructions; Assembling The Handle Bar; Mounting And Emptying The Collection Bag - Parkside PLV 1500 A1 Originalbetriebsanleitung

Residual Risks

There will always be residual risks
even if you operate this electrical
tool according to the instructions.
The following hazards may occur in
connection with the type and design
of this electric tool:
a) a) Cutting injuries
b) Hearing damage if suitable ear
protection is not worn.
c) Health injuries resulting from the
effect of vibration on the hands
and arms in the event that the
device is used over a longer pe-
riod of time or is not used and
maintained properly.
Warning! During operation,
this power tool produces an
electromagnetic ield. Under
certain circumstances, this
ield may negatively affect
active or passive medical
implants. In order to reduce
the danger of serious or fatal
injuries, we recommend that
individuals who wear medi-
cal implants should consult
their doctor and the manu-
facturer of the implant before
operating the machine.

Assembling instructions

Prior to any work on the implement
always disconnect the plug from the
power socket!
Ensure during assembly that the
power cable is not squeezed and
that it has suficient play.

Assembling the handle bar

1. Attach the lower bar (6) to the
B
appliance housing (8) and fasten
it using the two quick-release le-
vers and washers (7). The smooth
side of the washer should point
towards the quick-release lever;
the grooved side should point
towards the device.
2. Screw both central bars (5) with
the screws, quick-release levers
and washers (4) to the lower bar
(6). The smooth side of the washer
should point towards the quick-
release lever; the grooved side
should point towards the device.
3. Suspend the mains cable strain
relief (14) from the upper handle-
bar (3).
4. Screw the upper handlebar (3)
with the screws, quick-release
levers and washers (4) to both
central bars (5) to fasten.
5. Fasten the machine cable (15) to
the bar using the machine cable
terminals (11).
Mounting and emptying the
collection bag
WARNING: Never operate the
implement without the impact
protector. Danger of Injury!
The collection bag is only intended
for operation with the aerator cylin-
der ( 16).
A
1. Pull the collection bag over the rods.
C
2. Put the plastic straps of the col-
lection bag over the collection
bag rods and clip into the plastic
straps.
GB IE
27