Residual Risks; Assembling Instructions; Assembling The Handle Bar; Mounting And Emptying The Collection Bag - Parkside PLV 1500 B1 Originalbetriebsanleitung

GB IE
must be at least 2.5 mm
ways unreel a cable drum to its
full length so that the entire ca-
ble can be checked for damage.
• Use the envisaged cable suspen-
sion when attaching an exten-
sion cable.
• Never pull the cable to discon-
nect the plug from the socket.
Protect the cable from heat, oil
and sharp edges.
• If the connecting cable is dam-
aged, first disconnect the exten-
sion cable from the socket. You
can then disconnect the connect-
ing cable of the equipment.

Residual Risks

There will always be residual risks
even if you operate this electrical
tool according to the instructions.
The following hazards may occur in
connection with the type and design
of this electric tool:
a) a) Cutting injuries
b) Hearing damage if suitable ear
protection is not worn.
c) Health injuries resulting from the
effect of vibration on the hands
and arms in the event that the
device is used over a longer pe-
riod of time or is not used and
maintained properly.
Warning! During operation,
this power tool produces an
electromagnetic field. Under
certain circumstances, this
field may negatively affect
active or passive medical
implants. In order to reduce
the danger of serious or fatal
injuries, we recommend that
30
2 . Al-

Assembling instructions

B
1. Attach the lower bar (6) to the appli-
ance housing (8) and fasten it using
the two quick-release levers and wash-
ers (7). The smooth side of the washer
should point towards the quick-release
lever; the grooved side should point
towards the device.
2. Screw both central bars (5) with the
screws, quick-release levers and wash-
ers (4) to the lower bar (6). The smooth
side of the washer should point towards
the quick-release lever; the grooved side
should point towards the device.
3. Screw the upper handlebar (3) with
the screws, quick-release levers and
washers (4) to both central bars (5) to
fasten.
4. Fasten the machine cable (15) to the bar
using the machine cable terminals (11).
C
individuals who wear medi-
cal implants should consult
their doctor and the manu-
facturer of the implant before
operating the machine.
Prior to any work on the implement
always disconnect the plug from the
power socket!
Ensure during assembly that the
power cable is not squeezed and
that it has sufficient play.

Assembling the handle bar

Mounting and emptying
the collection bag
WARNING: Never operate the
implement without the impact
protector. Danger of Injury!