Silk'n FaceTite H2112 Bedienungsanleitung Seite 36

7. Using energy level 1, place the device on the area you want
to treat and make sure that it is in full contact with the skin.
EN
You will feel a mild sensation of warmth.
8. Move the device gently in linear massage-like motions
across the area you wish to treat. Progress slowly and
carefully. Keep moving the device ensuring that the 3
electrodes (#2) stay in good contact with the skin as you
treat the area.
9. Increase the energy level gradually, by pressing the control
button (#4). Using the highest energy level will get the best
results, but it's important that you set the energy level that
is most comfortable for you.
10. With the device constantly in motion, treat the area for at
least 15 minutes in total. You will feel the skin temperature
increase as you increase the energy level. During the
treatment, your skin will get a little red. Don't worry; this is
normal.
11. After your treatment, long press the control button (#4) to
put the device into standby mode.
12. Remove any residual Silk'n Slider Gel from the skin, then
rinse the skin with lukewarm water. Dry the skin with a
towel, and apply a facial cream to sooth and moisturize it.
Silk'n Slider Gel (or any other water-based
clear gel) facilitates smooth movement of the
treatment surface (#1) over the skin, and enables
conductivity. To ensure safe and efficient
treatment, always start by applying Silk'n
Slider Gel and apply more gel if needed.
Stop immediately if you feel any discomfort.
34