Putting Into Operation - Venta LP60 Ultra Bedienungsanleitung

PUTTING INTO OPERATION

01 06
Attention! Make sure that the appliance is switched off and the
power plug is disconnected.
01 Unpack the appliance and set it up. Open the fragrance/filter
compartment 3+7, remove the pre-filter 5+9, remove and unpack the
VENTAcel filter 6+10.
02 Re-insert the VENTAcel filter 6+10 and pre-filter 5+9.
03 Close the fragrance/filter compartment 3+7.
04 Inserting the fragrance: Twist open the fragrance cap and insert it into
the fragrance holder 4/8. Insert up to three fragrances into the fragrance
holder 4+8.
05 The display 1 can be adjusted to three positions.
06 The power cable can be adjusted to the desired length by winding it up in
the cable compartment 11
Attention! The coupling of the mains cable must be plugged firmly into the
device!
Please remove the protective foil for
battery and remote control.
Connect the power plug and switch on the
appliance at the on/off switch 2 or with the
remote control 12.
18 GB
ON/OFF
Set fan stage