Kit Bag; Storage Bag; Transport; Care / Maintenance / Storage - Crivit IAN 103565 Bedienungsanleitung

2 . To deflate the side chambers / screw the
valves completely from their base mountings .

Kit bag

A kit bag is included with this article in which
the kayak is stowed away for transport and
storage . In order to close this, please use the
200cm rope . The kit bag is also useful when
afloat for the splash-proof safekeeping of provi-
sions, clothes etc . Please remember that this bag
is not watertight . For this reason, do not store
sensitive objects in it, for example, cameras .
For use aboard it is advisable to remove the
rope and to flatten and roll up the upper end,
closing it when necessary with the hook and
loop fastener .

Storage bag

A splash-proof storage bag is also included
which can be attached to the back of the front
seat using the hook and loop fastener .
Small objects can be stowed away here to keep
them dry but please remember that this bag too
is not completely watertight . Please do not store
sensitive objects here .

Transport

Always transport the kayak with two adults and
use the carrying straps
of the craft .

Care / Maintenance / Storage

WARNING!
Only use care products that do not
contain traces of acids or petroleum and
never use silicone-based products.
1 . Clean your kayak thoroughly after every use
with fresh water and mild soap to remove salt
crystals, sandy granules and other small dirt
particles . Leave it to dry completely .
2 . Lay both of the upper side pipes into the
inside of the kayak and fold them together
carefully .
10 GB
at the front and back
3 . Store your kayak in a clean and dry place
away from direct sunlight and somewhere
where there are no great temperature
fluctuations . Pay attention to the fact, that the
kayak is not wrinkled but lays flat, and keep
well out of the reach of rodents .

Repairs

WARNING!
You should not attempt to repair large
damaged sections by yourself.
You can repair small areas with the enclosed
repair kit .
1 . Deflate the kayak completely and clean the
area to be repaired with an alcohol-based
solution . Roughen up the damaged area
surrounding the hole or tear with a fine sand
paper .
2 . Cut a patch to cover the damaged area . The
patch should overlap the damaged area by at
least 1 .25cm on all sides .
3 . Apply the glue to the kayak as well as to the
patch . Allow to dry for approx . 3 minutes .
4 . Press the patch down firmly using a soft
object . Make sure that you are working on a
flat, even surface . Remove any air bubbles
with a rounded object, gently pushing the
bubbles in an outward direction .
5 . Always wait at least 12 hours after a repair
before pumping up the kayak once again .

Disposal

Please dispose of the product and packaging in
an environmentally friendly manner, separating
different materials for recycling as required!
Dispose of this item through an authorised
disposal company or through your local waste
disposal facilities - ask your local authority for
information if further guidance is required .
Ensure that you comply with all regulations
currently in force .