Blackmagic Design Blackmagic Pocket Cinema Camera 4K Installations- Und Bedienungsanleitung Seite 46

Recording Time Remaining
When a CFast or SD card is inserted, or a USB-C flash disk is attached to your camera, the
storage indicators at the bottom of the touchscreen show how much recording time is left on
the card or USB-C flash disk. The time is shown in minutes and varies according to your
selected frame rate and codec. The indicator automatically recalculates if either of these
settings are changed. When there is approximately five minutes remaining on your card or
drive, the indicator text turns red, then blinks when there is only two minutes remaining.
The indicator displays 'full' when a card or drive reaches maximum capacity.
Your Blackmagic Pocket Cinema Camera 4K's storage
indicator shows the name of your CFast card, SD card or
USB-C flash disk and the record time remaining in minutes
The card or drive name is also presented in a small bar above the time remaining. The bar turns
blue to indicate the camera is set to record to this card or USB-C flash disk. To record to a
different card or drive, press and hold the name of the card or USB-C flash disk you wish to
record to. While recording, the bar is red.
Tapping the storage indicators opens the storage and formatting menu.
Tap the storage indicators on your Blackmagic Pocket Cinema Camera
4K's LCD touchscreen to access the storage manager
This menu displays the amount of free space on each CFast card, SD card or USB-C flash disk
used by your Blackmagic Pocket Cinema Camera 4K, as well as the name of the card or drive,
length of the last clip, total number of clips, and the file format for each card or drive.
You can format your media from this menu. For more information, see the 'preparing media for
recording' section of this manual.
TIP Tapping the card or drive name in the storage menu sets it as the active card or
drive. Your Blackmagic Pocket Cinema Camera 4K fills this card or drive first.
Touchscreen Controls 46