Flex L3309-115 Bedienungsanleitung Seite 19

Angle grinder L3309-115/125/FR, L3410FR/VR, L3325FR
4. Press and hold down the spindle lock
(1.).
5. Using the stop key, loosen the clamping
nut on the spindle in an anti-clockwise
direction and remove (2.).
6. Insert the grinding wheel in the correct
position.
7. Screw the clamping nut (2a), with flange
face up, onto the spindle.
8. Press and hold down the spindle
lock (5).
9. Tighten the clamping nut (2a) with the
stop key.
10. Insert the mains plug into the socket.
11. Switch on the angle grinder with the
switch rocker (1) (without engaging it)
and run the angle grinder for approx.
30 seconds. Check for imbalances and
vibrations.
12. Switch off the angle grinder.
Operating instructions
Note
When the angle grinder is switched off,
the grinding tool continues running briefly.
Rough-grinding
Danger!
Never use cutting-off wheels for rough-
grinding.
– Angle of wheel 20–40° for best cutting
performance.
– Applying moderate pressure, move the
angle grinder backwards and forwards.
As a result, the workpiece will not
become too hot and there will be no
discoloration; nor will there be any
grooves.
Cut-off grinding
– Do not press, tilt or oscillate the angle
grinder.
– The angle grinder must always be
operated backwards, see diagram.
Otherwise, there is a risk of the angle
grinder jumping uncontrollably out of the
groove.
– Adjust the feed to the material which is
to be cut: the harder the material, the
slower the feed.
For further information on the
manufacturer's products go to
www.flex-tools.com.
19