Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
6)
Assemble the gun again (Fig. 5).
7)
Turn on the machine and spray the solvent or water into a container or a cloth.
8)
Repeat the above procedure until the solvent or water emerging from the nozzle is
clear.
9)
Turn off the machine and divide the spray gun. Press the hook (Fig. 5 "click") slightly
downwards. Turn the gun front part and gun rear part against each other and take
them apart.
18. Cleaning the Perfect Spray
spray attachment
1)
Screw of the container and empty it. Pull out the suction tub with container seal.
CAutiOn!
Never clean seals, diaphragm and nozzle or air holes of the spray gun with metal
objects.
The ventilation hose and diaphragm are only solvent-resistant to a limited
extent. Do not immerse in solvent, only wipe.
2)
Pull the ventilating hose (Fig.15, A) at the top from the gun body. Screw off the valve
cover (B). Remove the diaphragm (C). Clean all the parts carefully.
3)
Unscrew the union nut and remove the air cap and nozzle. Clean the air cap, nozzle
seal and nozzle with a brush and solvent or water (Fig. 16).
4)
Clean the outside of the spray gun and container with a cloth soaked in solvent or
water.
5)
Assemble the parts again (see "Assembly").
Assembly
The unit may only be operated with an integer diaphragm (Fig. 15, C).
1)
Place the diaphragm
of the valve. Also see the marking on the gun body.
2)
Place on the valve cover (Fig. 15 ,B) and screw it closed.
3)
Place the ventilating hose (Fig. 15, A) on the valve cover and on the nipple at the gun
body.
4)
Slide the nozzle seal (Fig. 17, 1) with the groove (slot) facing forwards into the nozzle
(Fig. 17, 2).
5)
Put the nozzle onto the gun body and find the correct position by turning it.
6)
Put the air cap onto the nozzle and tighten it using the union nut.
7)
Place the container seal from below on the suction tube and slide it over the collar,
while turning the container seal slightly.
8)
Insert the suction tube with container seal in the gun body.
30
(Fig. 15 ,C) with the pin facing upwards on the bottom section
W 687 E I-Spray
Werbung
Kapitel
Inhaltsverzeichnis
