EBARA Ego Bedienungs- Und Wartungshandbuch Seite 26

5.1.1.2 TURNING ON AND OFF
When the pump is first connected it will operate with factory settings, which is "automatic mode".
At each following start-up, the pump will operate with the last settings that were set prior to its last shut-down
GB
To switch the pump off, press and hold the
switched off, the OFF sign will remain visible on the numerical display.
To turn the pump on, press the
5.1.1.3 PUMP MODES AND PARAMETERS
To switch between modes, hold the
Confirm the selection with the
After confirming the operating mode, the settable parameter will be automatically displayed and blinking (except for auto
mode). If necessary, set the parameter value with
key to accept the given parameter.
To scroll through the parameters within a mode (W, m, m3/h, rpm) use
modified (see individual mode) within a mode with the key
selected value with the
5.1.1.4 SETTING THE PUMP TO THE FACTORY SETTINGS
To restore factory settings to the pump, press and hold all three keys for 5 seconds. The pump will be set to the automatic
mode of operation. The previously set values for pressure and speed will be deleted.
5.1.2 DIGITAL INPUTS
There are two digital inputs available on the pump that has different functionality. Inputs can be set by Ethernet connection
on the settings page and overviewed on the overview page.
Input
IO1
IO2
To operate IO2, pumps 24V power supply can be used.
5.1.2 RELAY OUTPUT
The relay output can be set by Ethernet connection on the settings page and overviewed on the overview page.
The relay output can be configured to:
key for 5 seconds, until OFF is shown on the display. When the pump is
key briefly.
key for 3 seconds and then select the desired operating mode with
key.
and
key.
Function Description
Run [Default]
Start/stop pump
Max Sets pump to operate with maximum power
No function No function
Run Start/stop pump
Max [Default] Sets pump to operate with maximum power
Pressure switch Decreases RPM when active
No function No function
keys then confirm the setting with the
and keys. Select the parameter that can be
and set the desired value with
26
or keys.
key or just press the
and keys. Confirm the