Operation And Modes - Klarstein VapoAir Opal Handbuch

Bedienfeld-Tasten
Taste Funktion
ON/OFF Power on/off
MODES To select the different modes
NIGHT Night mode on/off
HUMIDITY Set humidity
TIMER Set timer
DEGERMING Control HEATING and PLASMA function.

OPERATION AND MODES

Note: If no button or symbol is pressed within 15 seconds, the display will turn off
automatically. Press any button to turn it back on.
Before first Use
• For first Operation, put unit in the room temperature for half of an hour before
running.
• Use clear water not over 40 degree C
• Check the water basin, make sure it is clear.
Getting Started
1 Place the unit on a flat surface.
2 When you remove the water tank, you must switch on the child safety lock.
3 Fill the water into the water tank and then attach the tank cap.
4 Place the water tank on the base.
5 Plug the plug into the power outlet.
6 Press the POWER button, the display turns on and the unit starts in AUTO mode.
The AUTO mode symbol lights up on the display and the current temperature and
humidity is shown. After 15 seconds without further input, the display turns off again.
Press any button to turn it back on.
7 Press the MODES button on the unit to select one of the modes.
EN
19