Insert Batteries - REVELL Control THE BIG ONE Bedienungsanleitung

HELICOPTER PTER
Stabilizer
Coaxial rotor system
LiPo battery
CONTROLLER LLER
Starting position
Note: The throttle stick and
trimming dial must be in
the down position when
the controller is turned on.
Antenna
Indicator lights
Speed selection
switch
Throttle trim dial
Throttle Stick
ON/OFF-
switch
1. To open the battery cover, 2. Remove the battery holder
slide it downwards using the strap.
Note: Before recharging and after every fl ight, always wait 15–30 minutes for the battery to cool down in order to avoid damage. Never leave the helicopter unattended when recharging.
Always charge the battery on a fi reproof surface and in a fi re-resistant environment.
1. Turn off the helicopter and the controller (Pic. 1).
2. Carefully separate the connectors on the fl ight cable on the helicopter (Pic. 2).
3. Connect the 220 V mains adapter to the LiPo charger. Insert the mains adapter into
a plug socket. The RED LED on the charger lights up.
4. Insert the white plug on the LiPo battery carefully into the LiPo charger.
Do not force (pic. 3).
5. The battery takes about 180 minutes to charge. Never leave charging batteries
unattended. As soon as the battery is completely charged, the green LED indicator on
the charger will start to blink.
The helicopter can fl y for about 10 minutes after approximately 180 minutes of charging. The battery should not need longer than 180 minutes to charge. If the LED indicator does not illuminate after
this time, stop the charging process. See if the helicopter works and, if necessary, continue to fl y the helicopter until it runs out of power or the rotors stop turning. Then repeat the charging process
described above.
Warning: The LiPo battery warms up during the charging process. If it becomes extremely hot or exhibits changes to the outer surface, stop charging immediately.
Big_Heli_MHz_Anleitung_06.indd 7 Big_Heli_MHz_Anleitung_06.indd 7
Helicopter and Controller
LED indicator
Landing gear
Battery cover
LED indicator
Pitch trim dial
Left/right trim dial
(fi ne tuning)
Forwards/backwards
fl ight (pitch)
Left/right fl ight (roll)
Roll trim dial

Insert batteries

3. Insert eight 1.5 V AA batteries ac-
cording to the polarity indicated in
the battery compartment.
Charging the helicopter battery
Pic. 1
Pic. 2
Tail rotor
HEL HELICOPTER BATTERY:
Flight cable
ACCESSORIES:
Spare rotors
Automatic LiPo
Batteries
4. Replace the battery holder in the
compartment and slide the battery
compartment cover back up and close.
Pic. 3
ON/OFF switch
220 V AC adapter
charger
5. If the LED indicator emits
a continuous red light,
the battery charge is OK.
7
26.02.10 10:58 26.02.10 10:58