Herunterladen Inhalt Inhalt Diese Seite drucken

Insert Batteries - REVELL Control AVOCET Bedienungsanleitung

Microhelicopter
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
HeLicoPter
Stabilizer
Position light
coNtroLLer
Infrared signal
emitter
charging status LED
and POWER ON LED
ON/OFF switch
for power and
charging
Actuating regulator
(up & down)
1. Loosen the screw
on the battery
compartment cover
and push the cover
downwards.
Caution: The battery has to cool off 10-15 minutes before charging and after each flight to prevent the flight battery from being damaged. Always monitor the charging procedure.
1. Switch off the helicopter and the remote
control unit.
2. Pull the charging cable from the compartment
on the lower side of the remote control unit
(Fig. 1).
3. Carefully insert the charging cable plug into
the charging socket on the helicopter (Fig. 2).
The plug should fit into the charging socket
easily - DO NOT USE FORCE. If the plug is not
inserted correctly into the charging socket, the
helicopter may be damaged and there may be
a risk of injury.
4. Put the power switch on the remote control
unit to ON (charging) (Fig. 3).
5. The charging status LED will now light up green
to indicate the charging procedure (Fig. 4)
6. The charging procedure is complete as soon as
the LED lights up red.
7. Set the power switch to OFF after the charging
procedure and disconnect the charging cable
from the helicopter again.
6
Helicopter and Controller
Counter-rotating
rotor blades
Landing gear

Insert Batteries

Charging the Helicopter
After a charging period of approx. 30 minutes, the
helicopter is able to fly for approximately 8 minutes.
Tail rotor
Channel selector (A, B and C)
Forward/backward flight
Fly to the right/left
Trimming regulator
for turning to the
right/left
2. Insert six 1.5 V AA
batteries following
the polarity shown
inside the battery
cover.
Pic. 1
Supercharging
bushing
ON/OFF switch
Initial position
Caution: This
regulator has to point
downwards before
switching on the
remote control unit.
Battery
compartment
cover
3. Push the battery
compartment
cover up again
and screw it
shut.
Pic. 3
Pic. 2
Pic. 4

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

24044

Inhaltsverzeichnis