Technical Specifications - Kärcher FC 5 Cordless Bedienungsanleitung

Rollers do not turn
Rollers are blocked.
Illustration
 Remove rollers and check if an object has become
stuck in the rollers.
 Check that the rollers are screwed in as far as they
will go onto the roller holder.
Loud rattling when switched on
Rollers are too dry.
 Moisten the rollers/the device with 50 ml of water in
the park station.
Rattling noise in the suction head
There are parts (e.g. stones or splinters).
Illustration
 Remove suction head lid and clean the suction
head.
See Chapter "Cleaning the suction head".
Suction power decreases
The suction ducts and slits on the suction head are
blocked.
Illustration
 Remove suction head lid and clean the suction
head.
See Chapter "Cleaning the suction head".
Appliance is leaking waste water.
Waste water tank is overfilled.
Illustration
until
Illustration
 Empty the waste water tank right away.
See Chapter "Cleaning the waste water tank".
Waste water tank does not fit properly in the appliance.
 Check whether the lid is fit securely on the waste
water tank.
See Chapter "Cleaning the waste water tank".
Separator is blocked.
 Remove lid from the waste water tank and clean
the separator.
See Chapter "Cleaning the waste water tank".
The filter net of the waste water tank separator was
damaged during cleaning.
 Renew separator.
Appliance leaves streaks behind on the floor
Cleaning or disinfecting agents are not suitable for the
appliance or were dosed incorrectly.
 Only use detergents and care products approved
by the manufacturer.
See chapter "Detergents and care products".
 Follow the manufacturer's dosage instructions.
The initial moistening of the rollers was not used or was
not used long enough, meaning that the rollers are not
completely moistened (rollers therefore only clean par-
tially).
Illustration
 Completely moisten rollers.
22
Removing the handle from the basic unit
ATTENTION
Do not remove the handle from the basic unit once it has
been assembled.
The handle may only be removed from the basic unit if
the unit is sent out for service purposes.
Illustration
See illustration at the end of the operating instructions
 Insert screwdriver at a 90 degree angle in the small
opening at the rear side of the handle and remove
handle.
ATTENTION
Please ensure that the connection cable between the
basic unit and the handle are not damaged.

Technical specifications

Electrical connection
Nominal battery voltage
Protection class
Device
Protective class
Charger protection class
Rated power of appliance
Battery type
Operating time with full charge
Charging time for empty battery
Charger initial voltage:
Output current, charger
Performance data
Roller revolutions per minute
Filling quantity
Fresh water tank
Cleaning station
Dimensions
Weight (without accessories and
cleaning fluids)
Length
Width
Height
Cable length
Charger
Subject to technical modifications!
– 13
EN
25,2 V
IPX4
III
II
165 W
Li-Ion
approx. min
20
4 h
30 V
0,6 A
500 rpm
400 ml
200 ml
4,4 kg
320 mm
270 mm
1220 mm
1500 mm