Fronius MagicWave 2600 Bedienungsanleitung Seite 51

Preventive and
corrective main-
tenance
(continued)
Safety inspection
Safety markings
Copyright
When ordering spare parts, please state the exact designation and the
relevant part number, as given in the spare parts list. Please also quote the
serial number of your machine.
The owner/operator is obliged to have a safety inspection performed on the
machine at least once every 12 months.
Fronius also recommend the same (12-month) interval for regular calibration
of power sources.
A safety inspection, by a trained and certified electrician, is prescribed:
- after any alterations
- after any modifications or installations of additional components
- following repairs, care and maintenance
- at least every twelve months.
Observe the relevant national and international standards and directives in
connection with the safety inspection.
More detailed information on safety inspections and calibration is available
from your regional or national Fronius service centre, who will be pleased to
provide you with copies of the necessary documents, standards and
directives upon request.
Equipment with CE-markings fulfils the basic requirements of the Low-
Voltage and Electromagnetic Compatibility Guideline (e.g. relevant product
standards according to EN 60 974). .
Equipment marked with the CSA-Test Mark fulfils the requirements made in
the relevant standards for Canada and the USA.
Copyright to this instruction manual remains the property of Fronius Interna-
tional GmbH.
The text and illustrations are all technically correct at the time of going to
print. The right to effect modifications is reserved. The contents of the
instruction manual shall not provide the basis for any claims whatever on the
part of the purchaser. If you have any suggestions for improvement, or can
point out to us any mistakes which you may have found in the manual, we
should be most grateful for your comments.
XI
ud_fr_st_sv_00467 022003