Herunterladen Inhalt Inhalt Diese Seite drucken

Keeping Your Spa Clean; Winterizing - Jacuzzi J-470 Montageanweisung Und Bedienung Und Wartung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

2. Locate the drain valve on the front/lower panel. Hold the
larger (rear) body to prevent it from turning, then loosen and
remove the cap.
3. Attach the hose.
4. Rotate the rear valve body 1/3 turn counterclockwise to
unlock the drain valve.
5. Pull the larger (rear) body outward to open drain.
6. After the spa drains, perform steps 2-5 in reverse order to
close the drain prior to refilling the spa.
7. After refilling,turn on power to the spa and follow the steps
listed under "Start-up instructions"
N.B.: Always fill your spa through both filter fittings.
Keep your spa clean
To preserve the sheen of your spa's surface, it is crucial that you
avoid using abrasive cleaners or cleaners which have adverse
effects on the surface. Regardless of the cleanser used, use
extreme care to assure that no soap residue is left on the sur-
face. This could cause severe sudsing when the spa is refilled.
Headrest Care
- Clean the headrests in your spa as needed by wiping them with
a clean cloth or soft brush saturated with detergent soap. It is
not necessary to remove the headrests for cleaning.
- In order to remove the headrest should the spa remain unused
for a period of time or to replace the headrest, take hold of the
ends of each headrest and carefully pull towards yourself.
- To reinstall, over mounting strip and press down until headrest
mounting bracket emits a "click" sound. Then adjust headrest
height by simply moving up or down as desired.
Maintaining the Cover
Install the isolating cover each time the spa remains unused so
that the water heating and spa maintenance times are reduced.
To increase the duration of the cover, treat with care and clean
regularly with neutral soap and water; a periodic application of
specific products available through authorised resellers ensures
protection against UV rays.
N.B.: Never allow anyone to stand or sit on the cover.
Panel maintenance
The panels do not require any special maintenance. To clean
them, just wipe them with a clean cloth soaked in a soultion of
water and a neutral detergent.
ATTENTION: do not direct jets of water against against
the, since electro-mechanical parts of the spa are located
behind them.

Winterizing

I
Your Jacuzzi
®
Premium spa is designed to automatically pro-
tect itself against freezing when operating properly.
I D
uring periods of severe freezing temperatures, you should
check periodically to be certain that the electrical supply to the
spa has not been interrupted.
I
Under very cold conditions check that the filtration cycle is pro-
grammed for 24 hours ("Primary filtration cycle" chapter) and that
the automatic heating mode is active ("Water recycling" - "Auto-
matic cycle" chapters).
I
During the periods of non-use and/or prolonged interruption
of electric power during periods with very low temperatures it
is important that all of the water is removed from the spa
and protect against damages that freezing may cause.
For expert winterization of your spa, contact your author-
ized dealer.
In emergency situations, damage can be minimized by taking the
following steps:
- Disconnect the spa from the electric mains.
- Position the massage switch in position A (combo).
B
C
A
- Open the valve of the cascade with the correct knob.
- Follow the directions for draining the spa.
- Get the water out of the recessed seating areas and bottom.
- Remove the side cover panels and locate the pump drain plugs.
Remove the plugs to allow water to drain out.
Use a vacuum or other means to keep the water from flood-
ing the equipment compartment.
- Replace the drain plugs and screw them on.
- Loosen the clamp on the bottom of the heater and remove the hose.
After draining the water, re-insert it on the connection and tighten
the clamp again.
- Re-install cabinet panels and cover spa with the insulating cover.
74

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

J-415J-400J-495J-480J-460J-465

Inhaltsverzeichnis