Draining And Refilling; Keep Your Spa Clean - Jacuzzi J-300 Montageanweisung Und Bedienung Und Wartung

H
H. Place each cartridge back into skimmer well, then rotate each
cartridge handle clockwise to thread back into the fitting. Note the
direction of installation. Do not over tighten.
I. Install clean skimmer bag back onto clips as shown.
J. Tilt filter cover back against clips, then lift approx. 3/8" to
latch against spa shell.
L. Turn power to spa back on.
I
Periodically, both filter cartridges will need a more thorough cleaning.
I
We suggest cleaning as shown (Point F). Soak the filter
overnight in a plastic container filled with a solution of water and a
specific cleaning product.
I
The cartridges last approximately two years with proper care, ro-
tation, and water quality maintenance. Replacement cartridges
may be purchased from your Jacuzzi Premium dealer.

Draining and refilling

About every 3 to 6 months, you will want to replace the water
in the spa. Frequency of water replacement depends on fre-
quency of use, care taken in maintaining water quality, etc.
You will know it is time for a change when you cannot control
suds and/or you can no longer see the normal sparkle to the wa-
ter, even though the key water balance measurements are all
within the proper parameters.
WARNING! Turn off power to spa before draining it. Do
not turn the power back on until your spa has been re-
filled.
If it is extremely cold, and the spa is outdoors, freezing could
occur in the pipes of the hydraulic system (see the section on
"Winterizing").
To drain your spa, perform the following steps:
J
I
1. Turn off power to spa.
2. 2.
3. 3.
4. 4.
5. 5.
2. Locate the drain valve on the front lower plastic pan. Hold the
larger (rear) body to prevent it from turning, then loosen and re-
move the cap.
3. Connect a garden hose.
4. Rotate the rear valve body 1/3 turn counter clockwise to un-
lock the drain valve.
5. Pull the larger (rear) body outward to open drain.
6. After the spa drains, perform steps 2-5 in reverse order to
close the drain prior to refilling the spa.
7. After refilling,turn on power to the spa and follow the steps
listed under "Start-up instructions"
N.B.: Always fill your spa through both filter fittings.

Keep your spa clean

To preserve the sheen of your spa's surface, it is crucial that
you avoid using abrasive cleaners or cleaners which have ad-
verse effects on the surface.
Regardless of the cleanser used, use extreme care to assure
that no soap residue is left on the surface. This could cause
suds when the spa is refilled.
Headrest Care
Remove and clean the headrest cushions as needed with soapy
water using a cloth or soft-bristle brush.
N.B.: Always remove the pillows when adding chemical shock
treatment to the spa water. The pillows can be returned to the s-
pa when the sanitizer reading drops below 4 ppm.
To remove the headrests:
29